Certification Introduction

Argentina ENACOM certification is a mandatory certification for wireless and telecommunication products. All equipment connected to the public telecommunication network and using the radio frequency band needs to apply for ENACOM certification. For the export of wireless communication products to Argentina, it is required to apply for ENACOM certification. The original control unit of Argentina wireless certification was CNC, which was later changed to AFTIC, and then changed to ENACOM after 2015.

Basic information of ENACOM certification
Is mandatory certification: Yes
Test content: RF
Whether factory inspection is required: No
Local testing: YES
Local agent is required: YES
Certificate validity period: 3 years

Certification Category

There are two types of certification

Homologación (Argentine standard certification) or Codificación (recognized certification where no standard exists).

Applicable product scope

Testing is required for the vast majority of telecommunications line termination equipment and radio frequency equipment.

· All terminal equipment connected to the public telephone network;
· Low power spread spectrum communication products operating in the 2.4–2.4835 GHz frequency band;
· Most radio equipment.

application process

1. Send samples to Argentina for testing
2. No need for factory inspection
3. Certificate holder: Argentine importer
4. One certificate for one model
5. One certificate for one trademark
6. Certificate validity: 3 years

7. Certification cycle: 12-14 weeks (calculated from the time the sample arrives in Argentina for laboratory testing and complete documentation)

Note: Argentine importers or distributors must complete ENACOM registration to obtain the certificate

Application documents

1. Spanish manual
2. Product nameplate
3. Photos inside and outside the product
4. Test software
5. Technical specification
6. Technical data
7. Antenna specification
8. Basic customer information table
9. Argentine importer information (if any)
10. Samples 3 units

other

1. The output power must meet all the following test items:
Conducted power: 500mW (PK)
Radiated power: EIRP, 43dBm (PK) and 40dBm (AV)

Power Density: EIRP, 13dBm/MHz (AV)

2. The antenna gain value needs to be adjusted to meet the above output power requirements.

3, limited to indoor use.
FCC/CE test reports issued by relevant laboratories will be available for certification applications.